The sliding part of the frame can be moved to place in front of the open part of the bay window or to leave a passage between the interior and exterior.
Thanks to the properties of rigid Mostiglass® glazing, the brightness of the room is preserved.
The design of the rigid Mostiglass® glazing allows it to cover a surface of up to 3.5m2 without reinforcement bar.
Reinforcement bars can be used for larger areas.
The sliding Mostiglass® frame can be removed occasionally.
3 basic colors are available for the frame: white (RAL9010), anthracite grey (RAL7016) and light grey (RAL9006).
They cover most aesthetic needs.
Our frames offer a wide range of optional colors, with over 150 shades available according to the RAL color chart.
The Mostiglass® sliding frame offers many advantages
for a good fit, we recommend that you take note of the following information.
The spacing between the shutter and the window must be at least 3 centimeters.
Installation of this product presents no particular difficulties. The use of a drill is recommended for the fixing points on the wall.
Start by inserting the rolling carts into the rail provided for this purpose.
Insert the end stops into the slider rail.
Attach the rail to the top of the board.
Warning: check that the roller carriages and the end stops are correctly installed on the rail.
Use the rods already positioned on the Mostiglass® frame to attach it to the rolling carts.
Position the guide so that the groove is centered across the width of the opening.
Make sure the frame slides perfectly on the guide to ensure smooth movement of the slider.
Securely attach the guide to the floor to ensure stability and proper alignment of the product.
For good sealing, brush seals are provided and can be installed in the gaps to be filled around the frame.
To ensure good adhesion to their installation, clean with alcohol the part of the frame where the brush seals will be glued.
Brush seals are supplied with this product and are to be used to plug the gaps (if necessary) between the Mostiglass® product and the joinery and thus ensure the sealing of the system for optimal functioning of Mostiglass® technology.
In the case of final installation of the product the brush seals can be replaced by silicone seals.
GoCap, is a production company that manufactures products to your dimensions.
For installation, we work in collaboration with craftsmen, independent workers or handymen chosen by the customer.
Indications on the site allow you to take measurements.
We then remove a working set to make installation easier.
The dimensions to be given are those of the panel where your Mostiglass system will be positioned.
In most cases, the panel is the external tunnel built around the opening.
Roller frames may be removed occasionally.
You do not have to remove Mostiglass® in winter.
They are resistant up to -40°C.
Its buffer effect allows for gentle ventilation, without drafts and without being gripped by the cold. This is a way to protect closed windows and save on heating.
The material used is as transparent as a window.
Up close, the perforations are visible.
When viewed overall or from a distance, the Mostiglass® is almost forgotten.
The brightness is not attenuated, the view and the colors are respected.
RAL is a standardized color reference.
This helps avoid errors, it is accessible on the internet
or by clicking on this
link
.
